MIXVIBES Dj Community old forum

Hey guys.

About a week ago, My headphone got beaten up, I wasn't careful enought and I accdentaly pulled it out of my mixer folowd by a big drop on the ground.

Result: The wires in the jack plug came of from it joints, and the right earpiece broke of from the nuckle.

So I started thinking about what can I do, and I rebuilt it.

Well, it's not finised, only a soldering work is remaining, but I'll post the final result.

Untill then, check the pictures

Not a bad repair - you wouldn't know they had been broken.

If you watch closer, you'll be able to see cosmetic "bugs", but they are barely noticable, and the picture is too bad, to spot them.

I only left my solder in college, so I have to travel a bit, to make them finally together.

The headphones are completed

They are very nice

That's really quite impressive!

rhopkins wrote:That's really quite impressive!

It should be... I had to saw apart the original headphones, to be able to this one

Luckyly I didn't messed up the sides, so the sides are exactly the same as the original.

The only thing I will do later is to add a Neutric 3,5mm Jack plug onto the end