Numark ns7 with Cross 1.7

[wazza]

Hi all ...Is there a MIDI map in Cross for the Numark ns7 and v 1.7...???? Can the ns7 be MIDI mapped in Cross ( the HID MIDI vinyl turning platter )

[christiankoopmann]

Hey,

To my knowledge there is currently no mapping aviable but it should be possible to map most of the buttons on the fly.

To the jogs: I can't say how they send their MIDI message and what typ of message they send. so it could be easy or difficult to map the device.
I would check if you can find a MIDI command list of the controller and look over it if it is possible. If you don't know 100% you can post a link or the file or send it to me if you found it and I look on it.

regards
Christian

[wazza]

http://www.native-instruments.com/forum ... 1247201354

[christiankoopmann]

hey,

I looked at the MIDI channels and it should work (I can't say it exactly because it depends on what exactly the MIDI channel is sending. For example for my old Behringer BCD2000 I have a very big list of which command and what excatly for which state it sends commands and so on. The list you post gives only an overview about which button send what ) So Only an YES but it will not be easy to map the jogs!

I have no controler and I know from my Numark NDX800 that it is not easy to map the jogs and special functions like sliders or something else (displays Light output and so on!).

So it will not be done in one or two hours the mapping of the hole device!

regards
Christian