MIXVIBES Dj Community old forum

Hello mixvibes family. First time on. I have been DJing for several years. I recently perchased the U-Mix 44 to go with my Cross DJ software. The interface seems to only play on one channel. Is this something of a common defect with this unit or do I need to upgrade ? Any help is appreciated Thanks! J Beezy

hey welcome to mixvibes fourm, not shure about the U-Mix 44 setup and Cross, plenty of infomation about set for different sc and Cross when you get the oppunity ,please registar your software licence key on the forum to make yourself avaible of the benifits of the fourm, free updates to the software, stored /secure location for your licence key in case of loss, and the willing help of expericenced users and support staff. again welcome to mixvibes

Thanks Daniel, I will register my key. Looking forward to more insight. J Beezy

You need to install the asio drivers of the U-Mix44 and select it into Cross : downloads.php?cat=56

Hello family its been awhile. I have been doing live sound for a few months. But now that it is getting hot outside I am picking up on DJ gigs. My question is I noticed the difference between Cross DJ 1.4 and 1.5 is the control modes(absolute, relative etc.). I have the interface connected correct to the laptop and cd players but the control disc are not responding ( yes I am able to us my external mixer on both channels). Is that a patch download or an upgrade. That would seem to fix my problem unless I am missing something in my current software. Thanks! J Beezy

bjbalk wrote:Hello family its been awhile. I have been doing live sound for a few months. But now that it is getting hot outside I am picking up on DJ gigs. My question is I noticed the difference between Cross DJ 1.4 and 1.5 is the control modes(absolute, relative etc.). I have the interface connected correct to the laptop and cd players but the control disc are not responding ( yes I am able to us my external mixer on both channels). Is that a patch download or an upgrade. That would seem to fix my problem unless I am missing something in my current software. Thanks! J Beezy

u mean timecode cds? those wont work with Cross DJ, only with Cross!
check the compare chart and consider an upgrade to Cross if u wanna use timecode cds and/or vinyl

Hello Family; Can anyone help me with my calibration issue. I upgraded to Cross to solve my last issue of cd time code . When I click the calibration cue it does not change my very low percent rating ( 0% quality). I should be at 100% quality or close.. No happenings. In reading the manual I may have bad RCA cords. Besides that is there anything you all know that may help. Also I changed my mixer to Pioneer djm400. My other mixer had a bad hum and bleed over. Thanks!!

first: enter your new Cross serial# into the form you did with the crossdj one
second: i think you have too loud incoming signals. check if the inputs are selected correctly (phono/line) then reduce the levels of the line signal till it gets to at least ~95% quality

Thanks boc!! I will follow your wisdom. Get back to you later !