Page 1 of 1

VCI-100 Mapping

PostPosted: 31 Oct 2010, 16:47
by kooldjgrego
Good Morning Mixvibers,

I have not given up on my mixvibe family. Although I have not had the pleasure in using my Cross Pack or Home, I have purchased a VCI-100 but I can not get any response. Is there automatic mapping. Also:

I can not get my u46 control panel to open. What can I do?

Also, what do you think about the Maya. I want to be able to use the controller and my Technics.

Can I use the controller with Home?

Can I use Audio DJ 2 with Mixvibe?

you guys, here is where I'm at: Using my Behringer 2000 with my old Toshiba (2001) to do my sets.

Re: VCI-100 Mapping

PostPosted: 02 Nov 2010, 15:06
by Support@MixVibes
kooldjgrego wrote:Although I have not had the pleasure in using my Cross Pack or Home, I have purchased a VCI-100 but I can not get any response. Is there automatic mapping. Also:

Cross Pack
Cross
Cross DJ
there is no Home version.

There is an automatic mapping since 1.4

I can not get my u46 control panel to open. What can I do?

You need to use the panel in the settings of Cross.

Also, what do you think about the Maya. I want to be able to use the controller and my Technics.

The maya can do the job.

Can I use the controller with Home?

Home 7 ? Yes there is also a mapping for vci100

Can I use Audio DJ 2 with Mixvibe?

If it is asio : yes.

If you have a Cross Pack, you can use you turntables on the U46 with your vci100. No need to buy new hardware/software.