OSX Lion, DVS Ultimate & Cross Update

[quinnygoth]

:cool: check the manual for info this will be the quickes solution,, cant remember offhand dont use vinal,,will look whan i get a chance

I downloaded the update and found the manual online. However, I've read through the sections that I'd assume the Pass Through feature would be under but I can't find anything about it.

There's a section on Relative, Absolute & Flexible mode. I would have thought it would be there but I can't see it anywhere.

[daniel clark]

Part of the solution is in chapter 4.3 .. ,looked with search tool but didnt find anything,,,,,by this time tommorow there will be someone that has the easy answer

[Support@MixVibes]

The pass-trhu is directly into the channel mixer header. Just click on Player 'x' and it will switch to Line-in.

[quinnygoth]

The pass-trhu is directly into the channel mixer header. Just click on Player 'x' and it will switch to Line-in.

I'm sorry but I'm still lost. Sorry if I'm causing everyone a headache.

Maybe I should explain my set up...

I'm using two Technic 1210s, with a 3 channel Numark mixer. I have the U-Mix 44.

I've read through all the external audio sections in the manual but I still can't figure it out.

In programs such as Serato & Tratkor there's a simple button on the software interface that you click to activate the pass thru mode.

Isn't there one on Cross?

Thanks

[Support@MixVibes]

Again :

The pass-trhu is directly into the channel mixer header. Just click on Player 'x' and it will switch to Line-in.

So just click it !